Triumph 3WH
Commentaires
35 26 June 2025, 17:02
Roland Sachsenhofer AuteurI'm going to show you an experiment that I really wanted to try: how would I cope with a 3D print? To summarise, cutting the forest of struts is a challenge that I have only mastered very poorly, which has had an impact on the need for repairs so far. On the other hand, it's also a lot of fun. I'll show you three development steps for each picture. The last four pictures show the current status. Now it's time to pull some more cables, repair and check.....
26 June 2025, 17:10
Roland Sachsenhofer AuteurThis small experiment in 3D printing has now been completed; all in all: very interesting! The ability to snap off incredibly tightly placed struts in the most seemingly impossible places still needs to be developed.
The final photo shoot with Laurel and Hardy was great fun! Thanks to them for their time 🙂
29 June 2025, 05:43
Roland Sachsenhofer AuteurMates, I really appreciate your comments, thank you very much for your interest and your motivating words!!
29 June 2025, 16:19
bughunterThe bearded man's face looks like a motorcycle gang is moving into Scalemates!
1 29 June 2025, 16:21
Roland Sachsenhofer AuteurIn fact, not even scalemates is proof against these guys... 🙂
30 June 2025, 06:38
Roland Sachsenhofer AuteurThank you Christian, your word's are very appreciated!
1 2 July 2025, 08:30
Roland Sachsenhofer AuteurThank you both, much appreciated! You figures amazed me too, to be honest 🙂
8 July 2025, 16:28
