Grumman F6F-5K/3K Drone Groupbuild

 

Pattern for holes for ignition wires in the ignition ring (of 0,8x0,8 mm squere rod). 

It was worthy to use the ANT-parts: looks OK and save a lot of time  

For comparison: Eduards R-2800 

A little bit detailing on the inner side of the cowl + thinned edges in the area the cowl-flaps. 

 

 

 

 

Hinges as usual in last time made of pins of an electric connecting block.  

Trailing edge of the fixed surfaces is not inline. In contrast to that the trailing edge of both elevators is inline. It is correct: Eduard done a good work! 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

New pictures with reduced saturation for preventing candy-look.  

 

 

 

 

 

 

Result of the group build: left is Hanno Kleinecke -3K 

 

 

 

 

 

 

 

 

 

 

 

Reworked antenna configuration: double wire.